believable 600v welding cable manufacturer

huadong welding-cable free sample
huadong welding-cable free sample

600v welding cable Construction

welding cable

1. Conductor : Flexible bare annealed copper wire or tinned copper wire
2. Insulation: PVC or Rubber Material or EPR
3. Sheath: Natural rubber, Horoprene rubber or other syntheitic rubber,PVC or or CSP.
4. No.Cross-section: 10mm2, 16mm2, 25mm2, 35mm2, 50mm2, 70mm2, 95mm2, 120m2, 150mm2, 185mm2 , 240mm2.
5. AWG: 6, 4, 2, 1, 1/0, 2/0, 3/0, 4/0, 250, 350, 500
6. Color: Choice of Black, Orange, Red or Yellow Blue jacket, single & double insulated.

   We can customize according to your requirements.

What should know when laying 600v welding cable?

Check the type, insulation and appearance according to the design requirements before laying 600v welding cable. During transportation, installation or operation, you should avoid 600v welding cable bend and twist excessively. The minimum allowable bending radius of the cable shall meet the relevant technical requirements. In areas with severe chemical or electronic chemical corrosion, you should use sheathed cables or plastic cables with jute coverings. On the side, you should take corrosion prevention measures. When laying 600 volt welding cable, set aside sufficient spare length to compensate for deformation. In places where displacement is easy, the directly buried spare section should not be less than 1.5% to 2%. The outlet (entry) of the protective pipe shall also be reserved for 3 to 5 m for repair.

welding cable 1

The other notes when laying 600v welding cable.

Within 24 hours before laying carolprene welding cable 600v, if the average temperature of the storage place and the laying site of the cable is below the allowable value, it is not suitable for construction. When construction is necessary for special circumstances, you should preheat the cable. So that the 600 volt welding cable can be installed from the beginning of construction to the end of the laying. The temperature of the cable core and the outer surface are kept above 5 degree. Otherwise, the secondary heating is necessary. When laying 600 volt welding cable in cable tunnels and trenches, do not damage waterproof layer. Moreover, when laying 600v welding cable,it’s not suitable to cross. you should arrange cable neatly, and install signs in time. Please don’t hesitate to buy our cable.

black and blue welding cable

Our advantages: Hongliang Cable Group is one of the largest cable manufacturers and suppliers. As long as you need cable, you can rest assured to choose Hongliang.

Hongliang Cable-factory

Hongliang Cable-factory

Customer Case: We have exported wires and cables to more than 30 countries, such as: Russian, America, Yemen, South America, North America, Middle East, Africa, Asia, Oceania countries etc.

huadong-cable-customer

huadong-cable-group-customer-case-3

Please leave your requirement, we will reply you within 12 hours.

Your Name

* Your Email

Your Phone Number

Your Country

* Your Requirement